Mannesmann Demag RRI-90 Betriebsanleitung Seite 12

For impact and impulse wrenches: Only use impact sockets.
The use of safety-/working gloves is recommended.
Use ear protection as instructed by your employer or as required by occupational
health and safety requirements
Reasonable countermeasures have to be taken to keep the noise level as low as
possible.
Disconnect the air supply before changing inserted tools, accessories, repairs or
when the tool is not being used.
Always check that the mounted tool or accessory is not damaged. Breakage and
flying fragments can cause injuries.
Keep rotating parts out of reach of any body part.
In case of long hair, wear a hairnet otherwise it can be trapped causing injuries.
Never wear loose clothing, wear suitable clothing otherwise it can be trapped
causing injuries.
Only use accessories for this tool that are designated for this tool by it's
manufacturer.
Convince yourself that no persons are in the working zone or danger zone.
The advised minimum age for operating this tool is 18 years.
Keep away from whipping hoses, this can cause injuries. A broken air hose or a
hose that comes loose of the hose joint can start whipping. Shut down the air
supply immediately.
Keep the work place clean and organized, you may stumble and fall over a hose
on the floor. Slippery floors and objects on the floor are major causes of injuries.
This tool is not intended for use in potential hazardous areas and is not insulated
from coming into contact with electric power.
Wear the appropriate clothing to feel comfortable at the workplace.
Cold exhaust air should be diverted from hands and body.
Air under pressure can cause injuries, be aware of this.
Never direct the exhaust air to yourself or anyone else.
Do not use quick change couplings direct on the air inlet of the tool as these may
release during operation. Assemble at least 50 cm air hose with a hose joint of
shock resistant material.
In case universal twist couplings ( claw couplings) are used, the lock pins must be
mounted.
Do not exceed the maximum air pressure as indicated on the tool.
Never carry the tool by the air hose.
On overhead work, use safety helmet.