Operation; Remote Control; Switching The Leds On And Off; Constant Lighting In One Color - EuroLite LED IP FL-10 Bedienungsanleitung

If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

Remote control

The remote control is supplied with battery inserted.
A barrier foil between the battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the rear side of the remote
control. Otherwise operation of the remote control is not possible.
When actuating a button, always hold the remote control in the direction of the sensor. There must be visual
connection between the remote control and the sensor.
If the range of the remote control decreases (7 meters as a maximum), replace the
battery. For this purpose, on the rear side of the remote control press the small bar
with the groove to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type. Please dispose of
old and used batteries properly. Batteries are hazardous waste and should not be disposed of with regular
Brightness: Static color, 3 levels
Speed: Internal programs, 3 levels

Switching the LEDs on and off

The LEDs can be switched on with the button ON and switched off with the button OFF.

Constant lighting in one color

For constant lighting of all LEDs in one color, press the corresponding color button. Use the buttons
to adjust the brightness in 3 levels for the static colors.
domestic waste!
R
Color buttons
Static color
CAUTION!
LEDs off
LEDs on
OFF ON
G B W
Seven color fading and switching
FLASH
Internal program
White fading in and out
STROBE
Internal program
FADE Seven color fading
Internal program
SMOOTH Seven color switching
Internal program
14/15
and
00066542.DOC, Version 1.5