National Instruments SCXI-1000 Schnellstartanleitung Seite 6

Add a Module to an Existing SCXI System
You also can add a module to an existing SCXI system in multiplexed mode. If your system already has
a controller established, install additional SCXI modules in any available chassis slots. Refer to
Install the Cable Adapter
1 New SCXI Module
2 Existing SCXI Module
Step 5. Attach Sensors and Signal Lines
Attach sensors and signal lines to the terminal block, accessory, or module terminals for each installed
device. The following table lists device terminal/pinout locations.
Location
MAX
DAQ Assistant
NI-DAQmx
ni.com/manuals
For information about sensors, refer to
smart sensors, refer to
Step 6. Attach the Terminal Blocks
SCXI Chassis or PXI/SCXI Combination Chassis
If you installed direct-connect modules, skip to
Attach the terminal blocks to the front of the modules. Refer to
terminal block and module combinations. If you are using a TBX terminal block, refer to its guide.
SCXI Quick Start Guide
to determine which module to connect to the cable adapter, if applicable.
1
Figure 8. Installing the SCXI Module in an Existing System
Right-click the device name under Devices and Interfaces, and select Device Pinouts.
Select Help»Online Device Documentation. A browser window opens to
with the results of a search for relevant device documents.
Select the task or virtual channel, and click the Connection Diagram tab. Select each virtual
channel in the task.
Refer to the NI-DAQmx Help that installs with NI-DAQmx.
Refer to the device documentation.
ni.com/sensors
.
ni.com/teds
4
3
2
11 12
10
9
7 8
6 5
4
2 3
1
ON
3 SCXI Chassis
4 Existing DAQ Device
How to Access Pinout
. For information about IEEE 1451.4 TEDS
Step 7. Install the Cable
ni.com/products
6
Step 7.
ni.com/manuals
Adapter.
to determine valid
ni.com