Herunterladen Inhalt Inhalt Diese Seite drucken

Device Operation - Goclever HKITCHSJ Bedienungsanleitung

Küchenpresse
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
ATTENTION: the device will only turn on if all the elements are properly
assembled. There may occur a need to re-assemble the device. Always follow the
instructions in this manual.
VII DEVICE OPERATION
1. Plug in the device to the power supply.
2. Press ON in order to start juice pressing. If the device is not assembled properly,
it will not turn on, in that case check the placement of all elements carefully.
3. Place fruit/vegetable of your selection into the feed chute. In order to push the
food article, use the plunger (7).
4. In order to use reverse function, press and hold OFF/revert.
5. In order to turn off the device, press OFF/revert.
Strictly observe the allowable uninterrupted working time for the device.
Exceeding the allowable operating time may cause irrecoverable damage to
the engine.
TIPS
use the slow juicer to process soft and peeled frui and vegetables, the device is
not intended to grind seeds, blending chocolate, nuts, ice cubes, etc.;
do not proces frozen fruit and vegetables;
fruit and vegetables intended to proces should be cleaned, peeled, should not
contain pits or shells;
the products that are too big to fit feed chute should be cut into little slices, when
using products that contain much fibre, you should use the slices no ż 1,5 x 1,5 cm;
it is not advised to use fruit and vegetable that are dry or contain much starch;
while placing fruit and vegetable into the feed chute, use the plunger, never
place fingers or other tools close to the elements that are moving, as it can lead to
injuries podczas umieszczania owoców i warzyw w otworze wlotowym, posługuj
się popychaczem;
in case of using mixed fruit and vegetable, you should start processing with
softest articles and choose harder objects one by one.
VIII. CLEANING AND STORAGE INSTRUCTIONS
CLEANING
When the device is not used, or before thorough cleaning, it should be disconnected
from the power grid. It's easiest to clean the device right after use. Do not use
EN
abrasive agents, cleaning powders, acetone, alcohol, etc. to clean the device.
Before cleaning, turn off the device and disconnect the power cable, disassemble
the components in the following order:
- lid;
- pressing screw, filter, filter support;
- bowl.
20

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis