Magnat MTT 990 Bedienungsanleitung Seite 17

• Please carefully adjust tone arm height so that the tone arm is precisely horizontal and parallel to the record. To do this, simply turn the tone
arm height adjustment dial (19) at the tone arm base.
Attention: During the adjustment, you should lift the cartridge stylus up with the tone arm lift in order to avoid damage to the stylus.
• After having completed the adjustment, lock the height adjustment by turning the lock lever (18) clockwise.
5. Adjusting the arm lift height
When the arm lift is raised, the stylus tip should be approx. 10-15mm above the record. If an adjustment is necessary, please proceed as
follows:
• Raise the tone arm lift by pushing the cue lever (16) upwards and carefully guide the tone arm onto the tone arm rest (11).
• Adjust the height of the lift by turning the adjustment screw (10) either counter-clockwise (increase lift height) or clockwise (decrease lift
height). To do this, you need a small cross-slot screwdriver (not included).
Important: During the adjustment, the tone arm lift (9) needs to be gently pushed downwards.
• Double check the adjusted height by guiding the tone arm onto the raised lift above the record.
CONNECTION AND MOUNTING OF THE DUST COVER
1. Connecting the amplifier
Please use the supplied RCA cable (i) to connect the stereo audio outputs (21) of the turntable to the input of a phono pre-amplifier or a
dedicated phono input of an amplifier. Please pay special attention to correct channel assignment: The left channel is marked in white (RCA
socket and RCA plug), the right channel in red. Additionally, the ground line has to be connected to the turntable and to the phono amplifier. To
do this, carefully loosen the clamp screw (20), fix the fork shoe of the cable under the screw and tighten it again.
Attention: If your amplifier does not have a phono input, you need to use a separate phono pre-amplifier between your turntable and your
amplifier.
Type art.no. 149 700/149 700C: For the supplied cartridge Audio Technica AT 95E, a phono MM (Moving Magnet) input is required.
2. Connecting to the mains supply
Plug the supplied power cord (j) into the mains connector (24) and plug the other end into a power outlet.
Attention: The factory setting for the mains voltage selector (22) is 230V for use in Europe. If the turntable is set to 115V and connected
to a 230V power grid, it will inevitably be destroyed!
17
Fig. 9