Quick Start; Technical Specifications; Troubleshooting - Himoto E18 Bedienungsanleitung

Equipment required for maintenance
Allen driver
Lexan scissors Pliers
Instant glue Silicone oil 4x 1.2V AA battery

Technical Specifications

Model Part# Length Width
BUGGY E10XB 409mm 256mm
E10MT 422mm 335mm
TRUCK
E10XT 432mm 330mm
TRUGGY
SHORT
E10SC 453mm 256mm
COURSE
MONSTER
E10BP 440mm 335mm
TRUCK
DESERT
E10DB 500mm 256mm
BUGGY
HUMMER E10HM 420mm 253mm
RALLY CAR E10XR 520mm 260mm
34
INSTRUCTION MANUAL | MODE D'EMPLOI | BEDIENUNGSANLEITUNG
HIMOTO 1/18 OFF-ROAD CARS
Socket driver Socket tool (big)
Reamer Socket tool (small)
Grease
Wrench
Height Wheelbase Wheel Track
139mm 288mm 85mm 254mm
163mm 296mm 116mm 332mm
144mm 296mm 106mm 329mm
144mm 288mm 90mm 254mm
260mm 296mm 116mm 332mm
190mm 288mm 90mm 254mm
180mm 288mm 90mm 254mm
175mm 288mm 90mm 254mm
HIMOTO 1/18 OFF-ROAD CARS
Quickstart
1) Charge the battery
Charge the battery using the included charger.
Take note of the warnings!
Brushed:
NiMH Battery
3) Switch on the transmitter
Brushed Version

Troubleshooting

Problem
RC model does not move
Ratio
9.6
11.7
RC model does not respond to con-
10.9
trols
10.2
11.7
10.2
10.2
IN CASE OF MALFUNCTION, LOSS OF CONTROL, OVERHEATING OR SMOKE, STOP USING THE
10.2
MODEL IMMEDIATELY!
WWW.NEIDHART.COM | WWW.HIMOTO.CH
2) Install batteries inside the transmitter
Install the batteries while respecting the polarities.
Brushless:
LiPo Battery
Brushed Version
4) Connect battery and switch on the ESC.
Connect the battery to the ESC's battery connector.
Switch ON the ESC. The car is ready to run.
Brushless Version
Cause
Transmitter or receiver are switched
OFF
Transmitter batteries empty or
wrongly installed
Battery empty or faulty
Transmitter or ESC are switched OFF Switch ON ESC and/or transmitter
Transmitter channel reverse swit-
ches setting is wrong
Transmitter End Point Adjustments
(EPA) are set incorrectly
Empty batteries in transmitter or car Replace or recharge batteries
Brushless Version
Remedy
Turn on both the transmitter and
receiver
Check batteries charge state and ins-
tallation
Check or charge battery
Check the reverse switches setting
Check that EPA settings on transmit-
ter
35