Pairing Your Device - FRIEQ BTS-12 Gebrauchsanweisung

 When the battery status is low, the shinning LED light will turn from its original
blue to red. When the battery is running out, there will be a warning tone
prompting you to charge the speaker, and the bluetooth will automatically
disconnect.

PAIRING YOUR DEVICE

1) Make sure the BTS12 is fully charged.
2) Enable Bluetooth on your Bluetooth device (iPhone, iPad, Tablet). Bluetooth
controls are typically found in the tools or settings menu. Turn on Bluetooth
connectivity and make sure your device is "visible" or "discoverable."
3) Turn on your new BTS12 by switching the button on the back of the speaker to
"On"; there will be a warning tone indicating that the speaker is powered on
4) After turning on the BTS12, the LED lights should alternate between red and
blue. These signals indicate that the speaker is in "pairing mode."
5) Choose "add new Bluetooth device" or "setup Bluetooth device" on your
device. It will search for the Bolse BTS12.
6) As your Bluetooth device discovers possible items to connect to, it will list their
names. Select the device named Bolse BTS12. This will connect your speaker
to your Bluetooth device. There will be a notification tone indicating that the
Bluetooth is connected successfully.
7) If the pairing attempt fails or times out (roughly 3 minutes), restart both devices
and start the pairing process again (Steps 2–6).
8) Once paired successfully, the LED indicator lights will turn blue and blink once
every 4 seconds.
9) If you need to pair with another Bluetooth device, press the Play/Pause button
for 2 seconds; the speaker will be disconnected from the previous Bluetooth
device automatically, there will be a warning tone, and then you can repeat the
pairing process again (Steps 2–6)
10) Enjoy your music wirelessly anywhere you go!
3