Emerio GR-111972 Bedienungsanleitung Seite 6

GR-111972
PARTS DESCRIPTION
1. Glass panel
2. Rear cover
3. Heat switch
4. Thermostat control knob
5. Hooks
6. Feet
FEET ASSEMBLY
1. Ensure the heater is unplugged.
2. Set the heater upside down.
3. Secure the foot plates to the base by using the screws to fix firmly.
WALL MOUNTED
1. Ensure the heater is unplugged.
2. Drill three holes (diameter – 8 mm, depth – 40 mm) on the wall according to the chart below. Insert the
plastic anchor bolts and then the long screws. Long screws should protrude 5-6 mm from the plastic
anchor bolts. Fix firmly.
- 5 -
EN