Bauknecht GMI 61102 IN Kurzanleitung Seite 10

TROUBLESHOOTING
FAULT
E1 The anti-flooding system (where present) has been tripped.
E2 The water level limitation system has tripped.
E3 The appliance cannot heat the water.
Tthe temperature sensor is disconnected.
E4
E5 The appliance cannot take in the water.
E6 The appliance cannot drain the water from the tank.
E7 The dishwasher cannot measure the precise water quantity that has
been loaded.
E8 Problem on the water distribution system to the baskets.
E9 Water intake system malfunction.
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
Alarms E1, E2, E3, E4, E4,
•
The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the
•
execution of the program.
The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the
•
operation of the dishwasher is not harmed.
To «reset» an alarm is necesary:
Open and close the door, or turn off and on the machine. At this point is possible to program the
•
dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
All manuals and user guides at all-guides.com
DESCRIPTION
and E9 interrupt the current program immediately.
D GB
GB