Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Important safety instructions
2.
Maximum widespread load
3.
Product label
4.
Maintenance information
5.
Getting started
6.
Declaration of conformity
7.
Measurements
8.
Fault finding
1.
IMPORTANT SAFETY INSTRUCTIONS
DANGER
This furnishing has been investigated and found suitable for public occupancies and household
use. When using an electrical furnishing, basic precautions should always be followed, including
the following:
WARNING – To reduce the risk of burns, fire, electricshock, or injury to persons:
1.
Always unplug this product from the electrical outlet before cleaning.
2.
Unplug from outlet before putting on or taking off parts.
3.
Close supervision is necessary when this product is used/operated by, or near children,
invalids or disabled persons.
4.
Use this product only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
5.
Never operate this product if it has a damaged cord or plug, if it is not working properly.
6.
Keep the cord away from heated surfaces.
7.
Never drop or insert any object into any opening.
8.
Do not use outdoors.
9.
To disconnect, remove plug from outlet.
WARNING
No one should under no circumstances be underneath the table top whilst the product is being
operated(connected to power). If the product has to be serviced/repaired, the powercord must be
disconnected from the power outlet before anyone is allowed to be underneath the table top.
EN
READ THE OPERATING
!
MANUAL CAREFULLY
BEFORE OPERATING
THE PRODUCT
AND RETAIN FOR
REFERENCE PURPOSES.
10
2.
MAXIMUM WIDESPREAD LOAD
2-Columns one motor system 80 kg (Note! With the table top included)
Built in overload protection - This product has a built in overload protection. The reason for
this is to prevent mechanical parts from being damaged - if activated - the height of the frame is
adjusted 25 mm in the opposite direction.
Built in temperature and duty cycle protection - Duty cycle, max: 1 min/9 min. The built in
protection can be initiated If used with higher frequency - wait a short while and try again.
3.
PRODUCT LABEL - CE label with S/N
4.
MAINTENANCE INFORMATION
Maintenance: The desk, with its integral electronic components is designed to be completely
maintenance free. There is no need for any intermittent lubrication, adjustment or any
subsequent maintenance for the lifetime of the desk. Interfering with the electronics, motor,
transformer or frame will make the warranty to become unvalid.
CAUTION
Position electrical cords in such a way that they not can be damaged while the product either is
in use or not in use.
Cleaning. Cleaning of this product should only be carried out with means of a dry cloth.
11
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
