Passion Dream 7 Anleitung Seite 29

How to use your Aquacheck Test Strips:
Lime content tests, Alkalinity, PH and Bromide
• Test the total lime content of the water. If the value is under 100, add calcium Booster,
see number (1). Read the instructions before use.
• Test the alkalinity of the water. The ideal alkalinity is between the values 80 PPM and 140 PPM,
see number (3). If the value is above 140 PPM, use PH-. If the value is below 80 PPM, use Total
Alkalinity Control (TA=) (contact your dealer). Read the instructions before use.
• Test the total lime content of the water. The ideal PH-value is between 7.0 and 7.5, see
number (4). If the PH of the water is under 7.0, use PH+. If the PH of the water is more than 7.5,
use PH-. Thoroughly read the instructions on the package. An incorrect PH balance could cause
irritation to the eyes and damage to the spa.
• When using the spa intensively we advise you to use the Boost button.
This will temporarily release extra Bromine to keep the water crystal clear.
1. Dip the strip into the water and take it out again
2. Hold the strip horizontally for 15 seconds
3. Compare the colours
(1) The ideal values: between 100 and 500
(2) The ideal values: between 2 and 3
(3) The ideal values: between 80 and 140
(4) The ideal values: between 7,0 and 7,5
29