home overmax OVH - PARRY 2.0 Bedienungsanleitung Seite 6

CARPET SLIP ASSEMBLY
Put the steam head (B) with a pad attached on
the carpet slip.
HOW TO USE
1. Pour water into the tank:
NOTE: To fi ll the tank, use demineralized water only. Do not use tap water because
it may lead to accumulation of scale and in effect damage.
NOTE: Refi ll the tank with water when the device is inactive and unplugged!
• Take the tank (4) out of the main body (2).
• Remove the cap from the water tank (5).
• Pour water into the tank (4).
• Close the cap.
• Put the tank back into the body.
2. Insert the device plug into the socket.
3. Switch the device on with the on/off switch
(9). Red light around the knob (8) shows that
the steam mop is heating up.
4. When it is hot, the light will turn blue.
5. The steam head can rotate at various ang-
les thanks to which you can clean corners
and low areas.
6. Use a knob (8) to adjust the amount of ste-
am. Knob clockwise to increase the amount
and anti-clockwise to reduce the amount.
Two indicators under the knob indicate the
amount of steam generated.
USE AS MANUAL STEAM WASHER
NOTE: Before you start assembling the mop as a manual steam washer and before you
replace accessories, switch the device off and unplug. Make sure the device is not
hot.
1. Remove the tube (C) from the main body (B).
2. Remove the steam head (D) from the main body (B).
3. Insert the accessories adapter (L) into the main body.
4. Choose relevant accessories and put the adapter as showed by the arrow. Turn right
to secure it.
5. To generate steam, press the grip key (13).