Default Setting; Resetting To Default Setting; Attaching The Lid; Cleaning - Gewa Andromeda REC4 Gebrauchsanweisung

Default setting

Gewa Andromeda comes preset with Monostable functioning and GewaLink-channels 16-19
on relay 1-4.

Resetting to default setting

To restore Gewa Andromeda to the default setting, press and hold the programming button P
for 5 seconds until the indicator lamp flashes, and then press the programming button P
again within 2 seconds when the indicator lamp remains lit.
Note! Any Z-Wave pairing will be deleted.
Resetting a single relay
To restore a selected relay to the default setting, press and hold the programming button P
for 5 seconds until the indicator lamp flashes. Then, press the programming button for the
relay to be reset within 2 seconds when the indicator lamp remains lit.

Attaching the lid

On model IRZ-REC REC4 and IRZ-REC4 WM it is possible to attach the lid with the included
screws.

Cleaning

Dip a cloth into water with a little detergent in it and wring it out well. This can then be used to
clean the outer casing of the receiver.
20