Disposal; Return; Introduction; Purpose Of This Document - Camille Bauer SIRAX CT100 Betriebsanleitung

1.8 Disposal

Device may only be disposed in a professional manner!
The disposal of devices and components may only be realised in accordance with good professional practice observing the
country-specifi c regulations. Incorrect disposal can cause environmental risks.

1.9 Return

All devices delivered to Camille Bauer Metrawatt AG shall be free of any hazardous contaminants (acids, lyes, solutions, etc.).
Use original packaging or suitable transport packaging to return the device.
Damage by returning
Damages caused by improper returning, no warranties or guarantees can be given.

2. Introduction

2.1 Purpose of this document

This document describes the wound primary current transformer SIRAX CT100 and CT110. It is intended to be used by Installation personnel,
commissioning engineers, Service and maintenance personnel.
Scope
This handbook is valid for all versions of the wound primary current transformer of the SIRAX line. Some of the functions described in this docu-
ment are available only, if the necessary optional components are included in the device.
Required knowledge
A general knowledge in the field of electrical engineering is required. For assembly and installation of the device knowledge of applicable national
safety regulations and installation standard is required.

2.2 Scope of supply

Wound primary current transformer SIRAX CTxxx with Connection set
•
Operating manual (german and english)
•
Test report
•

2.3 Further documents

The following documents are provided electronically via www.camillebauer.com:
Datasheet SIRAX wound primary current transformer
•
Operating manual (german and english)
•
Flyer current transformer program
•

3. Functional description

Wound primary current transformers are used wherever small primary rated currents of 1 A or more must be converted by the measuring system
into usable, galvanically isolated secondary rated currents of 5 A or 1 A. The primary current as well as the secondary current is connected directly
via screw terminals on the order and rear side.

4. Assembly and installation

Ensure a safe working environment during assembly, installation and maintenance work. Disconnect the power supply of the
primary conductor and secure it against unintentional reconnection.
• The installation of the devices is arbitrary.
• Connect the primary current according to the connection diagram to the provided screw terminals. Note the marking of the primary terminals.
• The installation of the current transformers is carried out on a mounting plate using a foot mounting bracket. To do this, use the fastening aids
supplied.
• Connect now the secondary connections according to the connection diagram. Observe the marking of the secondary terminals.
PM 1001853 000 00 Wound primary current transformer SIRAX CT1xx line 8/12