Operation - ratiotec RTP 300 Bedienungsanleitung

Insert a thermal roll
1 . Open the top cover .
2 . Insert paper roll . Pull out some paper and then close cover .
3 . Turn on the RTP 300 .
4 . If required, press FEED to pull out the required amount of paper .
Note: Please make sure that the printable side of the paper shows outward. Otherwise,
the receipt cannot be printed. A red flashing light will appear if paper roll is empty, if it has been
placed incorrectly or the top cover is not closed.
Please only use thermal rolls with the following features or purchase them from ratiotec:
Paper: thermal paper
Width of roll: 57 mm
Maximum diameter of roll: 45 mm
Core diameter: 12 mm
Printing a test receipt
Turn off the device . Hold down the FEED key for several seconds . Simultaneously press POWER
shortly . The red and green lamp light up . Press FEED again, the RTP 300 will then print a test
receipt . The red light will flash if the paper roll is empty, if it has been placed incorrectly or the
top cover is not closed .

Operation

Switch ON/OFF: Connect the RTP 300 to your device by means of the supplied cables for data
transfer . Turn on the printer by quickly pressing POWER until the green energy light appears .
The RTP 300 is ready for data transfer and printing . To turn off, press POWER until the power
light disappears .
Note: Please turn off printer before removing or connecting any cable to avoid any possible
damage. Avoid high humidity and direct sunlight. Keep away from magnetic objects. During ope-
ration, do not leave the RTP 300 unattended. Turn off when device is not being used.
10 11