Buffalo CC770 Bedienungsanleitung Seite 9

Telephone Helpline: 0845 146 2887 (United Kingdom)
Troubleshooting
Fault
The unit is not working
The unit is not working - 'E'
flashes on the display
The unit is not working - '0'
flashes on the display
Appliance does not remove all
the air from the bag
Bags are not sealing correctly
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Safety cut-out activated
'Lid closed' switch faulty
Open end of bag not
completely inserted
Gaskets dirty
Open end of bag is dirty
Bag may be punctured
Incorrect bags used
Suction nozzle blocked
Sealing bar is overheating
Moisture in bag under the
sealing bar
Incorrect Sealing Time set
Bag too thick
Incorrect bags used
End of bag not placed above
channel
Indicator light comes on but
there is no weld
Imperfect weld
Action
Check the unit is plugged in correctly
and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified
technician
Allow appliance to rest for indicated
time before using again
Call BUFFALO agent or qualified
technician
Open lid and reposition bag
Clean gaskets
Clean bag
Replace bag
Call Vacuum Pack machine supplier
Clear suction nozzle
Open lid and allow sealing bar to cool
down
Ensure inside of bag is dry and free
from moisture where it is to be sealed
Alter sealing time
Use thinner bag
Call Vacuum Pack machine supplier
Move end of bag over channel
Inspect heating element for breaks.
Replace if necessary
Inspect Teflon fabric heating element
cover for breaks or damage. Replace
if necessary
Inspect silicon rubber pressure pad
for damage. Replace if necessary
Inadequate "cooling time". Allow at
least one second between operations
Eventually certain components such
as the heater element and the Teflon
fabric heater cover will require
replacement through "normal wear
and tear"
UK
5