Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Select your network in the column "Select" by checking the checkbox next to it.
43. The name (SSID) of your current network/router will now be visible in the "Network name"
field. Below you are asked to enter the password of your network. NOTE, this is case
sensitive!
You do not have to change anything from the pre-entered settings. In above example you
only have to enter the pre-shared key (the password).
44. Technically, the device is now ready for use. However, you do have the optional possibility to
change the name (SSID) and password of the repeater network (3). This will influence the
network name that will be visible on your Phone, tablet or PC. By unchecking the "Auto. Copy
from SSID router" checkbox, you can choose any name and password you prefer. E.g. it is
possible to give your repeater The name of the room it is used in most, like 'wifi attic' or
'garden'. If you choose not to personalise the SSID, it will be named identical to your existing
router, so all you equipment can switch between the repeater and router seamlessly.
45. If you wish to get more easy access to the setup page of your repeater after the installation,
you should make sure the "Auto. Config LAN IP address" checkbox is checked. This will
makes sure your repeater gets a new IP address from your router, which enables you to
Name current network/router
Your router password
18
Werbung
