Targus DEFCON CL Bedienungsanleitung Seite 8

Targus Notebook Security DEFCON CL Combination Cable Lock
®
2 Use the abrasive pad, then the alcohol wipe to prepare the area when
you will attach the DEFCON Security Base Plate.
3 After the alcohol dries, remove the backing on the base plate to expose
the adhesive and place it on the prepared location. If desired, secure the
base with the two screws.
14
Targus Notebook Security DEFCON CL Combination Cable Lock
®
NOTE: WHEN USING THE ADHESIVE BACKING, APPLY AT ROOM TEMPERATURE
-60°F (16°C), AND ALLOW IT TO BOND FOR MORE THAN 24 HOURS. NOT REC-
OMMEND TO USE IN OUTDOOR OR HIGH HUMIDITY ENVIRONMENT. BONDING TO
GLASS, CERAMIC TILE, WATER-ABSORBENT MATERIALS, COPPER, BRASS, OR
PLASTICIZED VINYL WITHOUT PRIMER SURFACE ARE NOT RECOMMENDED. TAR-
GUS RECOMMENDS USING BOTH ADHESIVE AND SCREW TO PROVIDE MAXIMUM
SECURITY. USING ONLY THE ADHESIVE PROVIDES MARGINAL SECURITY.
4 Place the DEFCON Security Base Plate cover as shown and slide it to the
left or right to secure it in place.
5 Insert your DEFCON cable lock.
15