Troubleshooting Table - Pekatherm AE802 Gebrauchsanleitung

1. Put the bandage onto a specific body part and fix it with the help of elastic straps.
2. Connect the battery to the bandage, and check that the battery has been properly
connected.
3. Insert the battery in the battery pocket, (fig. 4) and stick it on any area of the bandage
which is most comfortable.
4. At this point the bandage begins warming up and in a few seconds you will be able to perceive a
pleasant heat. Make sure the bandage is fixed correctly. Check that there are no creases or folds.
5. You may extend the treatment period if necessary; remember, however, that generally it
should not last more than 20 to 30 minutes (see "Reasonable heat treatment").
6. If the battery is not to be used for a considerable period of time store it disconnected
from the bandage. Half charge the battery before storing as explained in a specific section
of this manual.
BATTERY CHARGING
1. Connect the battery to the charger and plug the charger into the mains socket. (fig. 3)
Red LED indicates the charging cycle is on.
NOTE: Green LED indicates that the battery is already fully charged. In this case unplug it from the
charger and unplug the charger from the mains socket.
2. Charging cycle will take about 4 hours for a completely discharged battery. When
charging is over LED turns green. When the battery is fully charged disconnect it from the
charger. Unplug the charger from the mains to reduce consumption.
NOTE: Half charge the battery before storing if it is not to be used for a considerable
period of time. Proceed as follows: completely discharge the battery connecting it to the
bandage and then put it to charge for about 2 hours. Repeat the procedure at least once in
half a year.
PRObLEM
The battery may be connected the the bandage incorrectly. Check the
connection.
Remember that the battery may be completely discharged. Disconnect the
battery from the bandage, and proceed to fully charge (see chapter on battery
1. The bandage
charging).
does not warm
It may also be a question of feeling.
up
Remember that quick checks carried out with uncovered bandage are not
reliable. Try to cover the product with a blanket or a towel and wait at least
30 minutes. If you still do not perceive heat, take the product to an authorized
service centre.
If you perceive that the heat emitted by the product is insufficient, try the
2. The bandage following: remove the clothes from the part of the body to which the bandage is
warms up intended to be applied and then apply the bandage directly on the skin, covering
insufficiently its other side with a towel. This will increase heat transmission, as well as avoid
the dissipation of some of the heat.
Check the connection between the battery and the charger., and check if the
3. Battery does
charger is plugged in correctly. Check if your mains socket has voltage. If the
not charge.
problem persists take the product to an authorized service centre.
USE INSTRUCTIONS

TROUbLESHOOTING TabLE

SOLUTION
17
EN
ENGLISH