Chapter 2 - Installation And Connection; Installation Process - Multitech Systems MT5600ZDX Benutzerhandbuch

Installation Process

The installation of the MultiModemZDX consists of making the physical connections
necessary to render the modem functional with your computer. This includes making
the proper serial, phone line, and power connections.
POWER
Figure 2-2. MultiModemZDX Connections
To install your MultiModemZDX:
1. Attach MultiModemZDX to dial-up phone lines using the RJ11 telephone cord.
This is accomplished by plugging one end of the cable provided with the
MultiModemZDX into the telephone jack in your home or office; and plugging
the other end into the LINE jack on the MultiModemZDX.
The LINE jack is not interchangeable with the PHONE jack on the
MultiModemZDX. Do not plug the telephone into the LINE jack or the line cable
into the PHONE jack.
2. Attach your MultiModemZDX to your PC or terminal with an RS232 (or V.24)
cable (see Figure 2-1). Be sure to tighten the mounting screws on the DB
connectors.
3. Connect your telephone set to phone jack via RJ11 cable.
4. Attach your MultiModemZDX to the AC Power transformer and plugging the AC
connector into a live AC outlet.
5. Turn on power by flipping the "ON/OFF" switch on the side of the
MultiModemZDX to the "ON" position.
Use only the power supply provided with the MultiModemZDX. Use of any
other power supply will void the warranty and could damage the modem.
6. Make sure modem and computer/terminal serial port baud rates are adjusted. (Note
that several programs can check this for you. If you have MS-DOS 5.0 or higher,
a program called MSD.EXE [Microsoft Diagnostics] is in your DOS directory. Typing
MSD at the DOS prompt brings up a screen that provides a variety of information
about your computer. Select COM ports and it lists information about your com port,
e.g., UART Type, Address, and IRQ, to name a few. Once you know your serial
port's UART type, you can set your communications's software appropriately.)

Chapter 2 - Installation and Connection

RS232
DB25 to Computer
Power Connector
(to Transformer)
PHONE LINE
RJ11/PSTN Connection
RJ11/Phone Connection
11