Before The First Use - Rotel MILKFROTHER U210CH2 Gebrauchsanweisung

 BEFORE THE FIRST USE
o
The appliance can be used for finishing the following tasks separately: I. frothing
and heating milk; II. only frothing without heating; III. only heating, without
frothing.
o
Before using your milk frother, clean all the parts according to the section
"CLEANING AND MAINTENANCE".
o
Important: do not wash any parts in the dishwasher, and do not immerse the jar in
water. This may permanently damage the product and void the warranty.
o
The appliance is equipped with two accessories of mixing paddle and frothing
paddle, the mixing paddle is used for mixing milk during heating to prevent from
sticking. The frothing paddle is used for frothing milk during heating or is used for
frothing separately, but no heating. Select desired accessory according to your task.
o
NOTE: the max capacity of the jar is 450ml.
 OPERATION OF YOUR MILK FROTHER
o
Frothing and heating

Place the appliance on a flat surface.

Select frothing paddle, then open the lid and insert the frothing paddle onto
the shaft on the bottom of jar.

Fill the jar with the desired amount of milk (To ensure good result, it is
recommended the initial temperature of milk shall be 10-15℃ ), and replace the
lid.

NOTE: the max milk quantity permitted to add is 100ml, to avoid milk
overflowing after frothing.

Place the jar on the power base and connect the plug into a power outlet, the
indicator will light red.

Press the switch button once, the indicator will light blue. Then the appliance
will start to work. Once the temperature of milk has achieved about 68±10℃ ,
the heating element will stop heating and the frothing paddle will stop rotating
automatically; the indicator will illuminate red again until unplugging the power
outlet.

Note: During operation, you can stop operating by pressing the switch button
once.

When the appliance has stopped operating, pour out the warmed and frothed
milk from the spout to enjoy it.

Caution: Minimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the indicator will be
illuminated blue and flash, the switch button will not be activated, after about 5
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use