Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Spanntec-nut
Hexagon nut
3. Lock the work spindle by depressing the spindle lock. Loosen the round nut of the
upper cutting disc with aid of a pin-type face spanner.
4. Loosen the hexagon nut with aid of the fork wrench SW 17. Remove the nut and the
washer.
5. Remove the round nut and the front cutting disc.
Tension flange
6. Remove the Spanntec-spindle with the Spanntec-nut and the lower cutting disc.
Assembly
1. Insert the tension flange.
2. Assemble the machine in reverse order.
☞
Arrow on diamond cutting discs must agree with arrow on protective hood cover-
direction of rotation.
10
ENGLISH
Round nut with drilled
holes in one face
Spanntec-spindle
Loosen the Allen screw of the Spanntec-nut
Setting the
with the T-key (to stop).
cutting width
Move the outer diamond cutting disc to the
required cutting width.
Spanntec
To lock it in the required position fasten the
Allen screw tightly.
Set of distance
1. Loosen the screw and open and remove the
plates (special
protective cover.
accessory)
2. Lock the work spindle by depressing the
spindle lock. Open the round nut of the upper
cutting disc with aid of a pin-type face span-
ner and remove it. Remove the upper cutting
disc.
3. Loosen the Allen screw with the T-key and
remove the Spanntec-nut.
4. Fit the diamond cutting disc to the collar of
the reduction ring and push it together with
the distance plates over the Spanntec-spin-
dle. The collar of the reduction ring must face
outside.
5. Screw down the Spanntec nut on the Span-
ntec-spindle and the round nut on the Span-
ntec-nut.
6. Fasten the Spanntec-nut with aid of the spanner (to steady depress the spindle
lock).
☞
The number of the distance plates between the diamond cutting discs determines
the cutting width. Without distance plates (only with reduction ring) the cutting width
is 8 mm. The set of distance plates contains the following distance plates:
1 Spacing washer
2 Spacing washers
1 Spacing washer
☞
Arrow on diamond cutting discs must agree with arrow on protective hood cover-
direction of rotation.
7. Reassemble the tool (see above).
Setting the
Loosen the wing nut and set the depth gauge
cutting depth
to the required depth. Loosen the wing nut
and set the depth gauge to the required
depth.
☞
The cutting depth gets less as the diamond
cutting discs wear down.
☞
In order to prevent edges from the remaining
cut strip breaking out, set the cutting depth
slightly deeper.
Spanntec-
spindle
Spacing
washers
Reduction ring
Spanntec-nut
Round nut with drilled
holes in one face
1 mm
2 mm
3 mm
ENGLISH
11
Werbung
