Specifications - Denver CR-415 Bedienungsanleitung

Press the memory / memory + button; "P01" will blink in the display.
Press the memory / memory + button again to set the preset.
Repeat steps 2 through 4 to set more presets.
The unit can preset 10 stations totally for FM.
When "P01-P10" is blinking, press the Tune+ or Tune- button to select
the preset number.
When recalling preset stations, press memory+ / memory - to select the
preset number.
Sleep operation
When listening to radio, press Snooze / Sleep / DIMMER button (11) to
enter sleep mode. You can just adjust the sleep timer from 90 mins to
15 mins by pressing the Snooze / Sleep / DIMMER button (11). The unit
will automatically turn off after the selected time.
NAP timer function (count down timer)
During radio off mode, press NAP button (2) to turn on NAP mode,
the NAP time will keep flashing every 5 seconds press NAP button (2)
within 5 seconds can change the duration from 90 min – 10 min.
The alarm buzzer will sound for 30 min and then shut off automatically.
To stop the alarm buzzer, press the ON / OFF button (5).
Press the NAP (2) button has no effect during alram operation. Press
ON / OFF button (5) to cancel NAP function.

SPECIFICATIONS

Frequency range : FM 87.5 – 108 MHz
Battery backup :
Power Supply :
RESET
The reset button (23) is located on the back of unit. Use a ballpoint pen
to press it whenever you change the batteries, or unit is not performing
as expected. This will return all settings to default value, and you will
lose any stored data (alarm and clock settings).
Note :
- Ensure that the FM antenna is completely unrolled and extended for
best FM reception.
3V (CR2032 Flat Lithium battery x 1) not included
AC 230V ~ 50 Hz