Electrical Connections And Operation; Operating Instructions - Ramsey Winch Patriot Profile 12000 Betriebshandbuch

Electrical Connections and Operations
See the Installation Instructions for the Safety On/Off
switch, Part No. 282063, supplied with the winch, to
install the On/Off switch.
When installing winch, connect labeled motor leads com-
ing from solenoid assembly to appropriately marked
motor terminals as shown at right. Tighten nuts on motor
terminals securely then slip boots over connections.
Attach solenoid ground wire to ground bolt located on
bottom of motor (Winch ground wire is already installed
to ground bolt on motor). Refer to figure lower
right.
Route battery cables up to battery.
Connect red cable to positive (+) battery terminal.
Connect black ground cable to negative (-) termi-
nal of battery.
C : B
AUTION E SURE BATTERY CABLES ARE NOT DRAWN
TAUT ACROSS ANY SURFACES WHICH COULD POSSIBLY
.
DAMAGE THEM
For normal self-recovery work, your existing elec-
trical system is adequate. Your battery must be
kept in good condition. A fully charged battery and
proper connections are essential. Run the vehicle
engine during winching operations to keep battery
charged.
The remote control switch is water proof. It has push
buttons on either side. Make sure the motor has stopped
fully before reversing. To actuate winch simply plug
remote control switch into receptacle in cover of sole-
noid. Run winch forward and reverse to check directions.
Snap appropriate "IN" and "OUT" disc into proper thumb
cavity. Do not leave switch plugged in when winch is
not in use.
A
A
Battery
Cable (+)
Solenoid Mtg.
Bracket

Operating Instructions

The winch clutch allows rapid unspooling of the wire
rope for hooking onto the load or anchor point. The
clutch is operated by the shifter knob located on the gear
housing end of the winch as follows:
1. To disengage the clutch, move the clutch shifter knob
to the "OUT" position. Wire rope may now be
freespooled off the drum.
2. To engage the clutch, move the clutch shifter knob
into the "IN" position. The winch is now ready for
pulling.
5
View A-A
Solenoid
Assembly
Motor
Leads
Solenoid
Ground Wire (-)
Battery
Ground (-)