Nikon Slide Feeder SF-210 Referenzhandbuch Seite 25

The SF-210 can be mounted on the scanner whether the scanner is off or on and con nect ed to a
computer. If the scanner is on, before mount ing the feeder check that the status LED is glowing
steadily. The SF-210 should
Install the scanner as shown below, with the side vents uppermost. Slide the SF-210 into the
scanner's adapter slot, stopping when the feeder contacts the back of the slot. The feeder
should be oriented as shown below when inserted. Push the feeder until the con nec tor on the
rear of the feeder is seated securely in the socket at the back of the slot. The feeder is prop er ly
inserted if the status LED on the front of the feeder lights when the scanner is turned on. If the
scanner is on when the feeder is inserted, the feeder's status LED will blink to indicate that the
feeder has been inserted cor rect ly. In all other respects, the feeder LED functions in the same
way as the scanner status LED.
Status LED
If the feed mechanism for the SF-210 is not in the initial position when the scanner is turned
on, you will need to wait a few seconds for the feed mechanism to return to initial position
before inserting slides.
Cautions
• Do not place the scanner upright when inserting, removing, or using the SF-210.
• Wait until the status LED glows steadily or the scanner is off before inserting or removing the
SF-210. Do not attempt to remove or insert the feeder while the scanner is operating.
• When the SF-210 is inserted with the power on, or the scanner turned on after the feeder
has been inserted with the power off, the feed mechanism will return to the initial position.
While this operation is in progress, the status LED on the front of the feeder will blink. Do
not perform any operations while the LED is blinking.
• If the feeder does not slide in smoothly, remove it from the adapter slot and try again. Do
not use force.
be inserted or removed while the status LED is blinking.
NOT
Power switch
Vents
7-En