Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The various starting times for one day
Tip
do not have to be entered in chronological se-
quence. In the mode
arranges the starting times independently.
You can check the programmed starting times
by proceeding as described above, but with-
out depressing "–" (o) or "+" (p).
If the heating operation is to exceed mid-
night, the last economic operation is ignored.
Enter this starting time as first starting time for
economic operation on the following day. The
regulator recognises the correct sequence of
the starting times although the first starting
time for heating operation is set to a later hour
than the first starting time for economic opera-
tion.
Should there be a day on which no heating op-
eration is required (permanently, e.g. office
which is not busy on Sundays), please enter
the required starting time for economic opera-
tion (if necessary, the day before) and cancel
all further starting times up to the time you
wish normal heating operation to commence.
If on one day of the week continuous heat-
ing operation is required, please enter the re-
quired starting time for heating operation (if
necessary, the day before) and cancel all fur-
ther starting times up to the time you wish eco-
nomic operation to commence.
If you wish to carry out extensive alterations
to the programme, it might be better to start off
with the programme pre-set by the factory.
Proceed as described above to delete all indi-
vidually set starting times, until the display
shows
. Briefly depress the cancel
Select day +/-
button C (r).
After this, the programme pre-set by the facto-
ry reappears (for all days: 1
heating operation 06:00 hrs; 1
for economic operation 22:00 hrs, further
starting times
).
--:--
When no more alterations are necessary
close the lid.
38
the regulator
Select day +/-
st
starting time for
st
starting time
6.2.5 Control knob set to
"Holiday"
Setting the period of absence
Turn the control knobr (n) to
(e) shows:
Days absent +/-
0
4217-23.1/G
The number of days absent is set by depress-
ing the buttons "–" (o) or "+" (p).
Briefly depressing the button alters the
number of days absent by 1 day, when the
button is depressed for a longer period the
displayed days run faster.
Note:
The present day must be entered as
a day absent, i.e. the regulator
starts with the holiday programme
immediately. The day of return
should only be entered if no heating
operation is required for that day!
Example: You would like to leave your house
for a two weeks' holiday. You leave the house
Saturday afternoon. Return is planned for Sat-
urday, two weeks later, and you would like the
house to be heated by then.
If you enter the number of days absent shortly
before leaving, the number entered must be
"14" (Saturday, Sunday, ... Thursday and Fri-
day, since on the Saturday you return you
want the regulator to switch the heating sys-
tem on as usual.
TR 200
. The display
Werbung
Inhaltsverzeichnis
