Exfoliation Treatment Function; Cleaning And Maintenance; Cleaning The Attachments; Cleaning The Body Brush - Beurer FC 55 Gebrauchsanweisung

Note
To ensure comfortable treatment, do not press the rotating brush attachment too firmly on to the skin. Treat each sec-
tion of skin for a maximum of 20 seconds.
4. To end the cleansing treatment function, press the ON/OFF/speed button again. The body brush switches itself off.

8.2 Exfoliation treatment function

The exfoliation treatment function using the exfoliation attachment is ideally suited for gentle exfoliation to remove
dead or dry skin cells. Do not carry out treatment more often than 2x a week. Always carry out the exfoliation treat-
ment in the shower or bath.
To start exfoliating, proceed as follows:
1. Ensure that the exfoliation attachment is attached to the body brush.
2. Moisten the exfoliation attachment.
3. Moisten your skin.
4. Apply a shower gel or cleansing lotion directly onto the bristles of the exfoliation attachment.
5. To switch on the body brush, press the ON/OFF/speed button. The exfoliation attachment starts to rotate. We rec-
ommend that you start by using the slow speed setting. To choose the fast speed setting, press the ON/OFF/speed
button again.
6. Gently move the body brush in circular motions over your skin. Start with your feet and work upwards from there
in the direction of your legs, buttocks, stomach, back, chest, arms and hands. Do NOT use the body brush on the
face or pubic area. If you have problems reaching your back with the body brush, use the additional handle. If the
treatment is unpleasant, stop using the device or reduce the speed setting.
Note
To ensure comfortable treatment, do not press the rotating brush attachment too firmly on to the skin. Treat each sec-
tion of skin for a maximum of 20 seconds.
7. To end the exfoliation treatment function, press the ON/OFF/speed button again. The body brush switches itself off.
8. Cleanse your skin thoroughly with water to remove any residue from your skin.
9. Pat your skin dry with a towel and then apply a moisturising cream using even, circular movements.
10. Clean the attachment thoroughly with water after each use.

9. Cleaning and maintenance

9.1 Cleaning the attachments

IMPORTANT
Before beginning cleaning, pull the attachment off the body brush.
• Clean the attachment thoroughly with water after each use.

9.2 Cleaning the body brush

• Clean the body brush using only the methods specified.
• Clean the body brush after use with a soft, slightly damp cloth. If it is very dirty, you can also moisten the cloth with
a mild soapy solution. Do not use any abrasive cleaning products.
• Protect the body brush from knocks, moisture, dust, chemicals, drastic changes in temperature and nearby sources
of heat (ovens, heaters).

9.3 Replacing attachments

• In order to ensure optimum cleansing of your skin, we recommend that you replace the attachments after 4 months
of use.
15