Advanced Use - Plugwise Switch Handbuch

The Switch will now be ignored by the network.
It is impossible to remove a Switch that is screwed to the wall without
damaging the surround.

5. Advanced use

Connecting a Switch to another network
After a Switch has been removed from a network (see the explanation
above), it can be connected to another Plugwise system. To do this,
follow the normal installation procedure.
Deleting network settings
If you try to add the Switch to a Plugwise network and it does not come
online, you can delete the network settings from the Switch. The Switch
contains a LED indicator light. If the Switch is assigned to a network,
the light flashes if one of the rockers is pressed (the light is only visible
in low-light conditions). Follow the steps below to delete the network
settings.
Ì Press the top of the rocker marked | for three seconds. If the Switch
has two rockers, use the left rocker for this procedure.
Ì Press the bottom of the rocker (marked 0) for three seconds.
Ì Press the top of the rocker for ten seconds.
Ì If after pressing one of the rockers the indicator light remains on for
longer (several seconds), the network settings have been successfully
deleted. If this is not the case, repeat the procedure. A watch with a
second hand can be useful here.
Note: remove the batteries. As long as the Switch is not assigned to a
network, it will consume more power.
Switching appliances in multiple networks at the same time
Users with a Source Pro licence can operate more than one network
(multiple Sticks) simultaneously from Source. It is possible to create a
group consisting of one Switch and appliances from various networks.
The appliances will then be switched on and off using the Switch, but
only if Source is running.
14