Start-Up / Operating - Schmalenberger Fluvo C2 rondo Betriebsanleitung

OPERATING INSTRUCTIONS
6

Start-up / Operating

Never carry out a trial run with the motor as long as there is no water in the pump. A dry
run will destroy the mechanical seal in the pump!
fig. 30
• Switching the pump on and off
The pump is switched on by pressing the switching button (Z). After 2 seconds the pump
can be switched off by pressing the button again or a signal can be sent to the pump (on-
off function).
• Water supply control
By turning the knob (K
increases.
• Air supply control / Air bubble bath
By turning the knob (K
The air supply to the water causes the water jet to become softer (air bubble bath).
• Direction of jet
The nozzle can be turned in any direction.
• Counter-current swimming
Set the maximum jet speed. Swing the nozzle (Q) so that the water layer just under the
surface of the water begins to flow quickly.
• Attaching the massage set
Switch off the counter-current swimming unit prior to attaching the impulse-massage
nozzle.
Pull back the sliding sleeve (V), push the hose coupling (F) into the nozzle (D), press the
sliding sleeve (V) against the nozzle (D) and pull back on the hose coupling (F). That
causes the hose coupling to be locked in place
C2 rondo
Version: 27200 - D
8322
) clockwise the water supply decreases, anti-clockwise it
W
) clockwise the air supply decreases, anti-clockwise it increases.
L
K Air supply regulator knob
L
K Water supply regulatorknob
W
Q Nozzle
Z Switching button
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
61