Chesilvale DSTS2 Bedienungsanleitung Seite 4

TALK MODE
Dialling
Select dialling mode via the TONE/PULSE switch.
Connect to line and monitor to ensure the line is free, then switch to
TALK. Check for dial-tone.
It is possible to switch from PULSE to TONE at any time (but not from
Tone to Pulse).
Redial
Switch TALK to MONITOR to TALK, then press LNR. Digits are re-
dialled in the dialling mode they were entered previously.
After disconnection from the line, the LNR memory is kept for >5 min-
utes.
Timed-Break-Recall
For register recall. Press the TBR button to give a line-current break.
Mute
It is possible to cut-off transmission by muting the microphone.
Pressing the MUTE button will offer privacy or will reduce sidetone in
noisy environments. Release the button to talk.
Ground-start operation
DSTS2 may be used on ground-start (or earth- calling) lines. Con-
nect a ground to the green wire of the line-cord (pin 3 of the BT UK
plug - if fitted and pin 5 of RJ11 - if fitted). Switch the DSTS2 to TALK
then press and release the G/S button.
CORD SETS
A range of alternative cord sets for the DSTS2 are available. In addi-
tion we can also supply modular adaptors (break-out connectors) to
suit many types of modular and frame jack sockets. Please contact
your nearest supplier for further details.
BELT CLIP/HANGING LOOP
Rotate the clip to use as a hanging loop.
3