SweetLF SWS7105 Bedienungsanleitung Seite 3

d:Turn the locking device (A)
counterclockwise, remove the
retaining frame (B).
NOTE:
Remove the blade from the guards and use the brush for
cleaning. Do not clean more than one cutter and guard because
they are matched with each other. If you accidentally mix up the
cutters and guards, it may take several weeks to restore the best
shaving functions.
Clean inside and out with
a clean brush grille.
Make sure the shaver head
recess portion aligned with
the recessed portion.
h:Put the flange fork shaving unit into the slot
at the top of the shaver. Then Close the
shaving unit.
Note:
If the shaving unit closed sluggishly, check the shaving head to
make sure it is inserted correctly and the holder is locked.
e:Remove and clean the
shaving heads one by one.
Each contains a set of razor
head cutters and guards.
f:Put the shaving heads back
into the shaving unit.
g:Put the holder (B) back into
the shaving unit, then turn the
locking device (A) clockwise.
6.Store instructions
With a protective cap on the shaver
shaving heads to avoid damage.
7.Change blades
For the best shaving performance, we recommend replacing
blades regularly. To replace the blades, follow the steps
below:
a:Switch off the shaver. Disconnect
the shaver.
b:Press the release button to open
the shaving unit.
c:Pull out the Shave blades parts
from the shaver .
f:Ensure alignment of just shaving
heads recessed portion recessed
portion. (Replace it with adverse
way of the above sequence )
h:Put the flange fork shaving unit into
the slot at the top of the shaver. Then
close the shaving unit.
d:Turn the locking device (A)
clockwise to remove the
retaining frame (B).
e:Remove the shaving blades
and put the new one in the
shaving unit .
g:The holder (B) back into the
shaving unit, the clockwise
rotation of the locking
device (A).