Product Introduction - SweetLF SWS7105 Bedienungsanleitung

1. Product Introduction

Please read this user manual, as it
contains information about the wonderful
features of this shaver as well as some tips
to make shaving easier and more enjoyable.
2. Attentions
Before using this product, please read User manual
carefully and keep it for future reference.
•Close supervision is necessary when this shaver is used in
the presence of children.
•To avoid injury, never use the shaver if there is any
damage.
•The temperature range to operate, store and charge this
product is 0 ℃ ~ 40 ℃.
•This product can be charged by phone charger.
•The shaver is designed to be IPX7 waterproof and can be
washed directly under the water. It's not suggested to
immerse the shaver under water for a long time,which will
reduce the life time of the shaver. Remember to check if
the water is too hot to avoid scalding your hands.
•When you are on a trip, make sure the protective cover is
on to protect the shaver heads. If there is a significant
change in temperature, pressure, or humidity, please allow
the shaver 30 minutes adaptation to new conditions before
use.
•Use the USB charging cable in the package. Please
connect the shaver to an AC outlet with 5V output or less,
such as a phone charger or computer USB port.
3.Charging instruction
•
When Charging
5 white displays will all light on to display the remaining
battery one by one and light down one by one to show the
battery. When it was 0-10% of the electricity, the light
displays as red one. When reach to 10%, the red light turn
to white with flash. When filled to 20% capacity, the light will
become always bright and stop the flash immediately. At
the Same time the second white light become flashing.
When the fifth LED filled full battery , 5 LED will always light
and display full charge.
•
When the battery is fully charged
Fully charged needs 1 hour charging time to last approximately
120 minutes shaving time.
•
When the battery is running low
When the first indicator light turns red blinking, that means you
need to recharge the shaver.
.
•
Charging Procedure
a:Connect the USB cable to your adapter and other power
supply or directly to your computer
b:After the battery is fully charged, unplug it from the wall
socket and unplug the cable from the shaver USB plug.
4.Using
Connect the shaver to an AC outlet
with 5V output or less, such as a phone
charger or computer USB port.
a:Press the on / off button to open or
close the shaver.
b:The shaving heads detour on your skin.
Your skin may need 2-3 weeks to adapt to the SweetLF
shaving system.
c:Trimming sideburns: push the slide down key under the
sideburns knife to make sideburns knife pop out and trim
sideburns beard.
d:After shaving, press the on / off button to turn off the
shaver; then put on protective cover to prevent damage.
NOTE:
When the head is damaged, do not shave, so as not to d
amage your skin.
5.Clean instruction
Do not use compressed air, scouring pads, abrasive
cleaning agents or petrol, acetone and other corrosive
liquid to clean the shaver.
•
You can rinse the shaver under the tap or clean it with a
brush we equip.
•
Be careful when using hot water. Always check the water
temperature to make sure is not too high to prevent scald.
•
Clean it each time after shaving to obtain the best shaving
performance.
•
Damp cloth is available to clean the outside of the shaver,
but do not wipe the shaving blade parts with a towel or
tissue, as this may damage the shaving blades.
a:Switch off the shaver.
b:Press the release button,
and open the shaving unit.
.
c:Pull out the Shave blades
part from the shaver .