DEFA DVS90 Bedienungsanleitung Seite 3

ENGLISH
The alarm can be armed without activating the sensors.
This may be necessary if, e.g. a dog is left in the vehicle or the
vehicle is on a ferry.
With the ignition turned off, press the button on the window
module before arming the alarm. The LED will light up as a
confirmation when pressing the button.
When arming the system the LED will then start to flash
immediately, without the 20 seconds delay for sensor arming.
The sensors remain deactivated until the ignition is turned on,
regardless of how many times the system is armed and disarmed.
If the Remote Control is broken or lost, disarm the alarm
system as follows:
Consult your PIN Code Card and locate your
five-digit PIN Code.
Follow the instructions on the PIN Code Card
to disarm the alarm system.
Always keep your PIN Code Card with you.
1. Turn the ignition on.
2. Press the button on the Window Module as many times as the first digit.
3. Wait (approx. 1 second) for the LED to blink once. This indicates that the digit is stored.
4. Repeat steps 2 and 3 with the remaining digits. When the last digit is stored the LED
will flash rapidly to indicate that the correct PIN is entered.
5. If at any point you enter a wrong digit you may start over from step 2 as many times as
required.
TEMPORARY DEACTIVATION OF SENSORS
EMERGENCY DISARM
ENTERING PIN-CODE
Do not leave it in the vehicle!
Window module
LED
Button
3