User Manual - DEFA DVS90 Bedienungsanleitung

Our 40 years of experience in the development of automobile electronics systems is your
assurance of quality and durability for the DEFA Security alarm system you have purchased.
Quality is our top priority, both in development and in production. Please read this user manual
carefully and acquaint yourself with the various functions of your DEFA Security alarm system.
This user manual describes the functionality of the alarm system when it is correctly installed
in a vehicle using your original remote control for operating the system.
For using DEFA remote control - Please read the user guide for DEFA remote control.
Note! The alarm system is delivered with a PIN Code Card. Keep this in your wallet, not
inside the vehicle!
The alarm system can be equipped with DEFA remote controls, or be used with the vehicle's
original remote control.
There are also options regarding the sensor setup. The alarm system can be equipped with
any combination of a level sensor monitoring jacking of the vehicle, a motion sensor monitoring
interior motion, a glass breakage sensor etc.
The installer uses DEFA's programming system to setup the alarm system to fit each vehicle.
• Using the vehicle's original remote control:
Press the lock button on your vehicle's original remote control.
The vehicle's direction lights will flash according to the vehicle's locking indication.
The LED is illuminated for 20 seconds before it begins to flash. This confirms that the different
sensors are armed. When the system is armed, the LED will flash once every other second.
Note! The ignition must be turned off to be able to arm the system.
• Using the vehicle's original remote control:
Press the unlock button on your vehicle's original remote control.
The vehicle's direction lights will flash according to the vehicle's unlocking indication.
If an alarm condition has been registered during the armed period the siren will beep five times
and the direction lights will flash when the alarm is disarmed. The LED will give information
about what caused the alarm condition by flashing in sequences. See Alarm Trig Memory for
more information.
Note!
If the vehicle's remote control is equipped with a trunk compartment opening button,
the alarm system can be programmed to not trigger the alarm on trunk opening if this button
is used. When the trunk is closed the system returns to fully armed state.
2
ABOUT YOUR NEW DEFA ALARM
VERSIONS
ARMING
DISARMING
ENGLISH