Operation - Me VS-10 Betriebsanleitung

6. Remove all the nameplate screws (4d) and
take it apart to find the foil to be marked
between the two plastic parts.
7. Mark the foil with an indelible felt pen or
print a nameplate (width = 70 mm, height =
53 mm) using your PC and printer.
8. Place the marked nameplate (foil) between
the two plastic parts and screw
together again.
Connecting the door opener
The outside intercom has a floating contact
(10b) that the App will switch to operate a door
opener. The wiring diagram (Fig. 4) shows an
example where the power supply to the external
station also supplies the door opener. Ensure that
the supply is adequately rated (current drawn by
the door opener). The power supply should be
capable of at least 500 mA more than needed by
the door opener. Different power supplies may
alternatively be provided for external intercom
and door opener.
DIP switch 1 (15) may be used to set the
contact closed time for 2 or 5 seconds. Set the
switch to "ON" for 2 seconds or to "OFF" for 5
seconds.
DIP switch 2 (15) may be used to switch an
audio signal ON or OFF. The audio signal will tell
the visitor that the door opener is activated and
that the door can be opened.
Maximum contact power: 15 V 1A
Connecting external bell buttons
A button (floating) may be connected to terminal
(10c), e.g. as a storey call button. The outside
intercom behaviour will be the same whether this
button or the bell button are pressed.
Connecting the external gong
The terminal (10d) has a floating contact that
closes when the bell rings. An external gong, for
instance, may be connected here. Refer to the
Gong instructions for its connection. Terminal 10d
then replaces the button described in the Gong
instructions.
Maximum contact power: 15 V 1A
Connecting the VTX module
The separately available wireless VTX-Bell module
may be connected to the plug (21). Simply plug
the short connecting cable into this plug. Secure
the VTX-Bell with adhesive tape.
All BELL series receivers may be used as Fung-
Gong receivers.

Operation

Pressing the bell button will activate the outside
station and your Smartphone with the configured
App and any additionally connected gongs will
sound. The outside station will also sound a dial
tone (cannot be switched off or changed). You
may then use the App to speak to the visitor,
activate the door opener (if connected) and
17
ENGLISH | VS-10