Mounting The Lower Handle; Mounting The Upper Handle; Mounting The Grass Box - Delta Fox DG-CLM-3637 Li Originalbetriebsanleitung

Mounting the lower handle

1. Attach one end of the lower
handle (3) to the screw thread
on the apparatus housing.
2. Pull the ends of the lower han-
dle (3) slightly apart and put the
other end of the screw thread
on the apparatus housing.
The lug indicating the angular
position (3a) must face inwards.
You can lock the lower
handle in 3 angular posi-
tions (steep/medium/shal-
low).
3. Place the enclosed washers
(6a) in position. The curved
sides face the handle.
4. Turn the lower tightening levers
(6) clockwise.
5. Lock the tightening levers (6) by
pressing them in the direction of
the lower handle (3). The tight-
ening levers must be pulled tight
and then positioned against the
handle so that tightening can be
carried out with medium force.
If this fails, continue to turn the
tightening lever clockwise, or
loosen it by turning anti-clock-
wise (see small image).

Mounting the upper handle

1. Fasten the upper handle (1)
with the enclosed screws (2b),
the washers (2a) and the upper
tightening levers (2) on the right
and left of the lower handle (3).
The release button (17) must be
located on the right in the mow-
ing direction.
Two positions are possible.
2. Turn the tightening levers (2)
clockwise.
3. Lock the tightening levers (2) by
pressing them in the direction
of the handle (3). The tighten-
ing levers must be positioned
against the handle such that
tightening can be carried out
with medium force.
If this fails, continue to turn the
tightening lever clockwise, or
loosen it by turning anti-clock-
wise (see small image).
4. Clipping in the cable holders:
Clip in the cable holders (15) on
the upper (1) and lower handle
(3) and use them to fix the de-
vice cable (16) in position. At the
end of the bottom handle (3) you
can insert the device cable (16)
into an existing cable holder.
Release the tightening lever (2+6)
and fold the bow-type handle (1)
and the lower handle (3) together
so that the device takes up less
space. Make sure not to pinch the
machine cables while doing this.

Mounting the grass box

Wear gloves when mounting the
grass box (4), to avoid risk of in-
jury.
See also the enclosed information
for installation of the grass box.
1. Assemble the two parts of the
lower section (4a) of the grass
box.
2. Place the upper section (4b) of
the grass box on the lower sec-
tion (4a). It then locks into place
in the recesses provided for this
purpose in the upper section.
GB
87