Clatronic BDM 2466 Bedienungsanleitung Seite 16

31510-05-BDM 2466
C. Steps to take blood pressure measurement:
GB
a. Wrap the cuff around the wrist. Refer to Wrapping of Wrist cuff
as (Figure No. 5)
b. Sit upright on the chair to have correct posture.
Refer to correct posture in taking blood pressure as Figure No. 6.
c. Press START/STOP button. All elements display "888" in 3 seconds.
Afterward, displays the update time. The measuring blood pressure symbol
will flash the display and than the air pressure will automatically pump up to
180 mmHg. If blood pressure tends to be on the high level, the air pressure
will automatically increase to the required level for measurement.
Do not move or tald in the midst of taking blood pressur measurement.
d. After the air pressur is increased, it will slowly decreased. When the pulse rate
is detected, HEART RATE symbol will start flashing and simultaneously a
beep sound will be heard.
e. After taking blood pressure measurement, the Systolic rate, will be lasting
flash on the display for 1 minute.
D. Storing, recalling and erasing measurement data:
a. Storing data:
After each blood pressure measurement, the systolic rate, diastolic rate, heart
pulse rate and the time & date of specific day will be automatically stored. The
memory holds the latest 14 measurement data. If more than 14 measure-
ments, the memory will automatically clear out the earliest data.
b. Recalling data:
(1) Pressing RECALL button at normal time, nothing will appear on the
display if there is no data in the memory. If there is data in the memory,
the latest recorded set of measurement which are the Systolic rate,
Diastolic rate, heart pulse, including the recording time and date, will
appear and lasting on the display for 1 minute (60 sec.).
(2) Press RECALL button to read the next line of stored data. The data called
up on the display is numbered accordingly. After reading the recalled data
as rotatory 14-set of the stored data, press RECALL to switch to normal
time.
(3) To discontinue in the midst of reading of the data, press START/STOP
button to power off.
c. Erasing data:
(1) Take out the batteries and then refill 2 pcs batteries again.
(2) To discontinue if the data is erased. Press RECALL button, no data should
show up on the screen.
16
29.12.2004 14:54 Uhr Seite 16