How To Measure - Clatronic BDM 2466 Bedienungsanleitung

31510-05-BDM 2466
Display mark
Replace
batteries
Measuring error
Measuring
blood
pressure
symbol
A. Inserting batteries in position:
a. Open battery cover.
b. Refer to the picture in positioning batteries. (Figure No. 4)
c. All LCD segments appear on the display in 3 seconds.
d. Display 1 month 1 date, 12 hour 0 minute.
B. Setting Date and Time:
a. Press "MODE" button ("month" starts flashing)
Press "SET" button to set the correct month (1, 2, 3, ...12)
b. Press "MODE" button again ("date" starts flashing)
Press "SET" button to set the correct month
c. Press "MODE" button again ("hour" starts flashing)
Press "SET" button to set the correct hour in 12-hour format
d. Press "MODE" button again ("minute" starts flashing)
Press "SET" button to set the correct minute (0, 1, 2, 3,...59)
d. Press "MODE" button again to switch to normal time
(month, date, hour and minute appear on the display)
29.12.2004
8. Discription of display marks
Condition/Cause
Mark appears in the
measurement condition
and flashes when pulse
is detected.
Appears when the battery
voltage is excessively low
or the positions of batteries batteries at correct positions
are incorrect.
Appears when the accu-
rate blood pressure could
not be obtained accurately
Appears all the time till
the measurement being
completed.

9. How to measure

14:54 Uhr Seite 15
Correktive action
Measurements in
progress remain quiet.
Replace all two batteries
by new ones. Insert the
beware of the +/– directions.
Press "start/stop" button again
and re-measure. Or check
cuff if wrapped at the wrist or
according to instructions
Check palm if exerting effort.
Check if talking or moving
during measurement.
Check if posture is incorrect
GB
15