aidapt VG832 Aufbau- Und Wartungsanleitung Seite 3

4. The black locking nuts are designed to be tightened onto the chrome
tubing, allowing the tabletop to be put at any height or angle without the
risk of collapse under its intended use. However the design of this unit is
only meant to be adjusted to a 'finger tight' pressure, over tightening of
the locking nut could result in the plastic housing being damaged.
5. If already installed, remove the E clips from uprights on the U shaped base.
6. Take the U shaped base with the two welded painted tubular uprights
with pre punched locating holes and place the welded tubular uprights
into the two tubular sections.
7. Ensure the pre punched holes align with the holes found on the two
painted tubular sections. You may have to loosen the black locking nuts,
be sure to retighten the black locking nuts once you have achieved the
alignment.
8. Insert the two E shaped clips provided through the pre punched holes,
ensure that the E clip is fully located. FAILURE TO DO SO WILL MAKE THE
TABLE UNSTABLE.
N.B. Please note that over tightening the nuts in this way will
invalidate the warranty on this item, as this is misuse of the intended
application.
9. Turn your table over with the U section on the floor and your table is now
ready for use . If you wish to angle the top you can do so by up to 45o. To
achieve the desired angle release the black locking nut furthest away from
you and raise the tabletop to the desired height, then retighten the black
locking nut to avoid the top sliding back downward.
CLEANING
Clean your Table using a mild detergent with a slightly damp, soft cloth only. Only
use a mild detergent or disinfectant; never use an abrasive cleaner. After cleaning,
wipe the Table with a dry, soft cloth if necessary. Do not leave in direct contact with
a heat source.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
If in any doubt, please do not issue or use, but immediately contact your
supplier for service support.
Fixing and Maintenance Instructions
3
Ver. 4 01/2013 (1327)