Safety Requirements; Transportation - Komfovent DOMEKT REGO RECU P Installations- Und Bedienungsanleitungen

EN

SAFETY REQUIREMENTS

• To avoid accidents and/or unit damage, only a trained technician must
• The appropriate Personal Protective Equipment (PPE) attire is worn rela-
• Electrical equipment is rated, connected and earthed in accordance with
The air handling unit must be plugged in to an electrical outlet (with earth), which is in good order and corresponds
with all requirements of electric safety.
Before starting any operations inside the unit, make sure that the unit is switched off, and the power
cable is unplugged.
• Earth must be installed according EN61557, BS 7671.
• The unit should be installed according to Installation and Maintenance
• Before starting the unit, check correct position of air filters.
• Service maintenance should be carried out only in conformity with the
• If main cable is damaged, only manufacturer, service team or trained

TRANSPORTATION

The air handling units are ready for transit and storage (1 Picture). The unit is packed to prevent damage of the
external and internal parts of the unit, dust and moisture penetration.
Corners of the air handling units are protected against the damage – protective corners are used. The entire
unit is wrapped up in protective film. For transit or storage, units are mounted on timber pallets. The unit is fas-
tened to the pallet with polypropylene packing tape over protective corners..
When unit is loaded or unloaded by crane, cargo rope is fastened in its designated places.
Forklift truck or hand pallet truck can transport air handling unit as it is shown (2 a, b, c Pictures).
12
carry out the connection.
tive to the operation being carried out.
CE regulations.
Manual.
instructions specified herein below.
technician must change it in order to avoid accidents.
Air handling unit ready for transit and storage
UAB AMALVA we reserve the right to make changes without prior notice
1 Picture