Mustek powermust 600 led Benutzerhandbuch Seite 3

(1) Inspection
The following items are inside the box:
● UPS unit ● User manual
(2) Connect to Utility Power
Connect AC power cord to utility power. Then, the UPS will start to charge inside
battery. For best result, charge the battery for 6 hours prior to initial use.
(3) Plug in Equipment
Battery Backup Outlets(3)
Connect computer and monitor to the "Battery Backup" outlets. These outlets provide
battery backup, EMI filtering, line conditioning, and surge protection. Battery power
is automatically provided in case of power failure.
Surge-Protected Outlets(3)
Connect a printer, fax machine, or scanner to the "Surge-protected" outlets. These
outlets do not provide power during power failure.
CAUTION: NEVER connect a laser printer or scanner to the battery backup sockets
of UPS. The equipment may draw significantly power to overload the UPS.
(4) Turn On/Off the UPS
To turn on the UPS unit, press the power switch lightly. Then, the LED or LCD will light
up. To turn off the UPS unit, press the power switch again. Then, display will shut off.
LED Alarm
●Green Off
Sounding every 10
★Yellow
seconds
★Yellow Sounding every second
Off
○Green
●Red Continuously sounding
●LED on ○ LED Off ★ LED flashing
UPS Status
The mains is normal and UPS is
operated normally.
Power failure occurs and UPS is on
battery mode.
Low battery
UPS is off.
UPS fault
4
Problem Possible Cause
Problem Possible Cause
Nothing is The UPS is not on.
Nothing is The UPS is not on.
displayed on the
displayed on
panel.
Battery voltage is too
the panel.
Battery voltage is too
low.
low.
Battery fault.
Battery fault.
The UPS always Power cord loose.
The UPS Power cord loose.
on battery mode.
always on
Backup time too Battery voltage is too
battery mode.
short. low.
Overload.
The UPS Please check the fault
continuously code for the details.
beeps.
Backup time Battery voltage is too
Battery defect.
too short. low.
Overload.
MODEL PowerMust 600 LED
CAPACITY
Input Voltage
Input Voltage Range
Battery defect.
Output Voltage
Regulation
Transfer Time
Waveform
Battery Type
Battery Number
Charging Time
Dimension (DxWxH)mm
Net Weight (kgs)
Humidity
Noise Level
Solutions
Solutions
Press the power switch again to turn
Press the power switch
on the UPS.
again to turn on the UPS.
Charge the battery at least
Charge the battery at least
6 hours.
6 hours.
Replace the battery.
Replace the battery.
Re-plug the power cord.
Re-plug the power cord.
Charge the battery at least
6 hours.
Remove some devices. Before
Please check the fault code
reconnecting equipment, please
for the details.
check that the load matches the UPS
capacity specified in the specs.
Charge the battery at least
Replace the battery.
6 hours.
Remove some unnecessary
loads. Before reconnecting
equipment, please verify
PowerMust 800 LED
that the load matches the
600VA/360W 800VA/480W
UPS capability specified in
220/230/240 VAC
the specs.
180-270 VAC
Replace the battery.
± 10 % (Bat. mode)
Typical 2-6 ms
Simulated Sine Wave
12V/4.5Ah 12V/5Ah
1 1
4-6 hours recover to 90% capacity
305 x 158.5 x 95
2.6 2.9
0-90% RH @ 0-40°C non-condensing)
Less than 40dB
5