Technical Data - LaserLiner PipeControlMobile-Camera Bedienungsanleitung

Connection for control cable
2
When screwing the control cable to the VideoControl-Master
base unit on top, ensure that the arrow on the connector plug
points toward the groove of the respective device.
!
The sensitive contact pins of the connector only fit into the socket in this position and can be
damaged if not positioned correctly or used too forcefully.
Roll up push rod
3
To roll up the push rod properly,
push the cable into the reel.
!
The cable should not be rolled up by turning
the reel.

Technical data

Type of camera
Camera head
Protection class
Camera resolution
Field of vision
Focal depth
Reel diameter
Cable diameter
Cable length
Minimum bending radius
Operating conditions
Storage conditions
Weight (without accessories)
Dimensions (W x H x D)
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: http://laserliner.com/info?an=pcmc
PipeControlMobile-Camera
CMOS image sensor
ø 25 mm, water-resistant
IP 68 (immersion depth 20 m, 1h)
640 x 480 pixels
73°
5 ... 60 cm
31 cm
5,8 mm
20 m
70 mm
-10°C ... 60°C, Max. humidity 20 ... 85% rH,
no condensation, Max. working altitude 4000 m
above sea level
-20°C ... 70°C, Max. humidity 80% rH
1,48 kg
310 mm x 310 mm x 120 mm
Subject to technical alterations. 18W04
07
EN