Assembly/Dismantling; Use Of The Swivel Seat - Vermeiren Paris Gebrauchsanweisung

The swivel bath transfer seat is a 360° turning
bath seat that allows easy transfer over the
bathboard. The seat can be locked into four
90 degree positions. The user sits on the seat
from the side of the bath and then swivels
over the bath for a wash or shower.
The construction of the seat allows full use by
elderly people or during revalidation in home
environment.
The seat shall not be used as toy for children.
The seat should only be used on horizontal,
non smooth surfaces of the bathtub board.
The manufacturer is not liable for damage
caused by the lack of or improper service or
as a result of not following instructions from
this manual.

6. Assembly/Dismantling

CAUTION: Chance of pinching - Do
   
not place fingers
components of the seat.
CAUTION: Risk of clamping - Keep
   
fingers, cloths, jewelry or items away
from moving parts of the seat.
The Paris seat is foreseen with removable
arm supports, removable backrest and has a
swivel seat that can be locked in four 90°
positions.
1
Fig 2. Mounting / removing arm supports and
backrest
6.1. Removing arm supports
1. Push on the two pens c located on the
bottom side of the arm support tubes
(just below the seat).
2. Pull on the arm support.
6.2. Mounting arm supports
1. Push the tubes of the arm supports in
the tubes of the lower frame.
2. Check that the arm supports are well
fixated. When you hear that the pens c
clicks in the holes, the arm supports are
good fixated.
between the
2
1
3
6.3. Removing backrest
1. Push on the two pens d located on the
outside of the backrest tubes (just
below the backside of the seat).
2. Pull the backrest backwards.
6.4. Mounting backrest
1. Push the tubes of the backrest in the
tubes of the lower frame.
2. Check that the backrest is well fixated.
When you hear that the pens d clicks
in the holes the backrest is well fixated.

7. Use of the swivel seat

The swivel bath transfer seat is ideal for
usage in a bathtub. The specially designed
rubbers at the end of each attachment leg will
create a safe stability for the seat and avoid
the sliding over the bath board.
The seat can be mounted on the top of the
bathtub and can be easily removed when not
in use. So other persons can use the bath.
7.1. Mounting the swivel seat to the
bathtub:
1
2
Fig 3. Mounting / removing swivel seat to the bath
CAUTION: Risk of injury - Check that
   
the seat is properly fixed in the
bathtub with the positioning screws.
CAUTION: Risk of injury - Check that
   
at least 30 mm of each attachment leg
rest securely on each side of the bath.
1. Place the swivel seat with the four
attachment legs c on the board of the
bathtub.
2. Turn the positioning screws d on both
sides against the bath.
3. Turn the wing screw against the lower
frame.
4. Check that the swivel chair is properly
fixated to the bath.
Paris
2012-07
1
2
1