Safety Instructions; Installing The Batteries - Velleman ZLLS1 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the
environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the device was
damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not
accept responsibility for any ensuing defects or problems.
• This torch is for indoor use only.
• Use only NiMH rechargeable batteries. Do not try to recharge non-rechargeable batteries. Remove the batteries when
the device is not being used.
• Note that damage caused by user modifications to the device is not covered by the warranty.

3. Installing the Batteries

• Open the battery compartment by holding the upper part and turning the lower part in an anti-clockwise direction.
• Insert 3 x AA rechargeable batteries. Observe the polarity.
• Close the torch.
4. Description
1. LED light
2. SOS button
3. power on/off
4. M mode
5. Use
• Charging the Torch
Insert the charging dock into the mains (230VAC/50Hz). Insert the torch into the dock and switch on the torch. The blue
charge LED will light to indicate the torch is charging.
ZLLS1_v2
ZLLS1 – RECHARGEABLE LED TORCH
2 VELLEMAN