Lakeland Let’s Bake 31575 Gebrauchsanweisung Seite 7

When adding or removing the bowl, splatter guard or attachments the arm
must always be raised. Press the 'TILT' button to raise the arm.
Attaching the bowl
• Place the bowl onto the bowl lock, slotting the
tabs around the bottom into the notches inside
the bowl lock. Hold the bowl with both hands and
twist clockwise following the 'Lock' arrow, until it
is securely in place.
Attaching the splatter guard
• You can use the splatter guard when mixing
flour and liquid, to prevent splattering and
flour dusting. For other jobs you may not need
the splatter guard.
• Place the splatter guard, into the splatter guard
lock. Holding it with both hands, line up the
arrow on the splatter guard with the unlock
symbol on the arm. Twist it clockwise towards
the lock symbol to lock it into place.
Adding the attachments
• Select your attachment. Underneath there is a hole
with two notches, line these up with the tabs on
the attachment lock.
• Push the attachment up over the notches, as far as
it will go, then twist the attachment anticlockwise
to lock it into position.
• Make sure the attachment is securely locked
into place.
• Press the 'TILT' button and move the arm into the
downward position with your other hand, the
'TILT' button will click fully out. The splatter guard
should fit over the bowl.
• The Let's Bake Stand Mixer is now ready to use.
To remove the attachments
• Push the attachment upwards into the attachment
lock as far as it will go, then twist clockwise to
release.
TABS
NOTCHES
ARROW
NOTCHES
UNLOCK
TABS
NOTCHES
7