JVD T29 Gebrauchsanweisung Seite 26

The remote sensor should be securely mounted onto a horizontal surface.
Note: Transmissions between receiver and transmitter can reach up to 30m in
open area. Open Area: there are no interfering obstacles such as buildings, trees,
vehicles, high voltage lines, etc.
6. Temperature
6.1 RF Transmission Procedure:
The outdoor sensor will automatically transmit temperature signal to the main unit

after batteries inserted.
If main unit failed to receive transmission from outdoor thermo sensor in first 3

minutes after the batteries inserted ("- - . –"display on the LCD), hold "SEARCH"
button (B1) for 3 seconds to receive transmission manually. RF icon "
the LCD
6.2 Temperature
After start-up, the unit would display Indoor & Outdoor Temperature, and Past 24

Hours Maximum and Minimum Indoor & Outdoor Temperature Record.
Hold "SEARCH" button (B1) for 3 seconds to clear the record on outdoor channel

manually, and receive the transmission from outdoor automatically again.
6.3 Celsius / Fahrenheit
Press "°C /°F" button (B4) to select Indoor/Outdoor Temperature in Celsius mode or

Fahrenheit mode.
If the temperature is out of the measurable range, LL.L (beyond the minimum

temperature) or HH.H (beyond the maximum temperature) will be shown on the LCD.
6.4 Temperature Alert function:
Press "ALERT" button to select to activate the alert function, and corresponding alert

icon ( or
Activate Upper Limit of Outdoor Temperature Alert function
Activate Lower Limit of Outdoor Temperature Alert function
Activate Upper & Lower Limit of Outdoor Temperature Alert function
or ) would be displayed on LCD, sequence as follow,
flashes on
"
26