Fitting The Syringe Assembly To The Titrator - Grundfos Selcoperm 98842487 Bedienungsanleitung

HandyStep S titrator
2
3
4
Fig. 1 HandyStep S titrator
Pos. Description
1 Stroke setting wheel (slow/rapid dispense)
2 Dispensing lever
3 Titration scale (units dispensed)
4 Locking/filling lever
5 Syringe ejector
1
5
Syringe assembly with 3-way valve
9
Fig. 2 Syringe assembly with 3-way valve
Pos. Description
6 Syringe, 1.25 ml
7 3-way valve
8 Dispensing tube
9 Titrant cartridge
2.2 Fitting the syringe assembly to the
titrator
A B
Fig. 3 Fitting the syringe assembly to the
titrator
1. Hold the titrator vertically (titrating position). Push
the locking/filling lever to its lower stop (A).
2. Push the locking/filling lever down gently, until it
inclines.
– The locking bar inside the titrator opens (B).
3. Insert the top of the syringe assembly into the
titrator. Pull the locking/filling lever back to its
starting position.
– The locking bar inside the titrator closes (C).
The syringe assembly is held firmly, ready to use.
6
7
8
C
5