Music Playing; Troubleshooting - Egg R300 Usb Bedienungsanleitung

SET Time display and calendar setup.
Setting the calendar: Press and hold the SET button to enter the calendar setup mode. The
numbers for the year start fl ashing. Use
using
exit by pressing any button.
Time display: If the display does not show hours, you can fi nd the current time by briefl y
pressing the SET button.
SLEEP Switch off timer. You can set the timer to the following time intervals: OFF, 15, 30, 45, 60, 75,
90, 120 minutes. The default setting is OFF (timer is inactive).

Music Playing

1. Press MODE to select one of four playback sources: SD card, USB drive, AUX input or FM radio.
2. SD/USB: Connect SD card or USB disk containing music. Press
and to set volume. You can pause and restart playback by pressing
are preferred to other sources, you can connect them any time and start playback immediately.
3. AUX: Press
4. FM: Press and hold
fi ne-tune it.
Tip: There is no pause function available in the FM and AUX mode.
PC/mobile telephone mode
1. If you want to play music from an external device, connect the external device with this one using the
supplied audio cable with 3.5 mm connectors. Press MODE to switch to AUX mode.
Power
1. You can power the device using USB connector or batteries (size AAA).

TROUBLESHOOTING

Problem
The radio does not work,
the LCD is not on
SD card/USB drive
FM receiver did not fi nd any
or only a few radio stations
No audio from the AUX
output
EN
30
and set the desired number. Set the day, hour and minute the same way and
and to set volume.
to start automatic tuning, press briefl y
Solution
Check, if the batteries are inserted correctly.
Check, if the power is correctly connected.
Check, if the device is on, or if the backlight of the display is off .
Check, if the device is switched to the playback mode.
Check, if the SD card or the USB stick are correctly inserted.
Check, if the SD card, or the USB drive contain songs in MP3 format.
Make sure that the device is switched to FM radio mode.
Make sure that you use the device in accordance with the instructions for
FM radio.
Make sure that there are FM radio stations within range.
Make sure that the external device is properly connected with this one
using audio cable with 3,5 connectors.
and to select a number, press again SET and
and to select a song and hold
. The SD card and the USB disk
to select a station and using and