Tally TallyCom III Twinax IIF-4 Schnellinstallationsanleitung Seite 2

ENGLISH
This Quick Installation Guide explains how to install your
PrintServer.
Caution: Static electricity can damage the interface. You
should either wear an antistatic wrist wrap, or frequently
touch the metal surface of the printer.
Install Interface in Printer
1. Make sure no power cord is connected to the printer.
2. Install the interface into the printer's slot by way of the
printer's manual.
3. Find an unused device address (0-6) on the iSeries/
AS/400. Use the prtdevadr command.
Network Installation
1. Set the device address (0-6) using the red ADDR switch
on the Twinax interface. The white marker on the switch
indicates the current setting.
Possible positions of the ADDR switch:
•
•
•
2. Connect the Twinax cable and power on the printer.
Generate Settings Printout
1. Record the current position of the red ADDR switch on
the rear panel of the interface.
2. Turn the switch (clockwise) to position T (TEST) and
back to the original position when the printer has started
printing.
3. Verify correct device address on the printout.
0,...,6 - Device address (0-6).
T - Test and settings printout.
A and B - For service personnel only.