Using The Timer - Phottix Aion P9M-AIONTX Bedienungsanleitung

Disconnecting the Timer or Receiver
from the camera
1. Turn off the Timer or Receiver and camera.
2. Remove the Phottix Accessory Cable from
the camera's remote port.
3. Remove the Phottix Accessory Cable from
the Timer or Receiver.

Using the Timer

The Phottix Aion Wireless Digital Timer has two
modes: Shutter release modes and Timer mode.
Changing modes on the timer
Press the Sound / Mode Button to cycle between
modes. A small indicator line will appear on the LCD
over the selection. The modes are:
S: Shutter Release. A half-press of the Stutter
Button will focus, a full press will open the shutter.
The LED on the Timer and Receiver will light green
when focus is achieved.
4
C: Continuous. A half-press of the Stutter Button
will focus, a full press will open the shutter and take
five photos. The LED on the Timer and Receiver
will light red as the images are recorded. Holding
the Stutter Button will result in more photos being
recorded, in groups of 5.
B: Bulb. A half-press of the Stutter Button will focus,
a full press will open the shutter and lock it. The LCD
screen on the timer will begin to time the exposure.
The LED on the Timer and Receiver will light red. To
stop the exposure fully press the Stutter Button to
close the shutter.
2S: 2 Second. A half-press of the Stutter Button
will focus, a full press will take a photo after a two
second delay. The LED on the Timer will flash green
while the 2 second delay is underway and red when
the image is recorded.
Timer: Gives access to the timer mode functions.